What Is Michelin P265/70r17 Tire Pressure?

What is the recommended tire pressure for Michelin tires?

A typical passenger car tire, properly inflated to 35 psi ( pounds per square inch ), can lose up to 1 psi per month under normal driving conditions, according to Michelinman.com. Therefore, you should check your tire’s pressure cold, or before you’ve driven for the day, at least once every month.

What PSI should tractor tires be?

So, while a standard radial tractor tire may need 35 PSI to pull a heavy planter on the road, “by putting an IF tire on that tractor, we can reduce that inflation pressure down into the 20s,” Harris says. “It helps us use a lower inflation pressure to do the least amount of compaction into the soil.”

What PSI should my 10 ply tires be?

Light Truck Tires

LT-Metric, LT-Flotation and LT-Numeric Light Truck Tires
Load Range Ply Rating Maximum Load Pressure > 295mm / 11.5″ wide
D 8 50 psi (350 kPa)***
E 10 65 psi (450 kPa)***
F 12 80 psi (550 kPa)***
You might be interested:  Often asked: What Is The Diference Of Michelin Pailot Super Soport 105y Y 101y?

Is 80 psi too high for tires?

The 80 psi is required if the tire is operating at rated load. You most likely have a load range E tire. I have run load range E tires for years on my 4 Runners at 32 psi front and 30 psi rear. This gives me real even tire wear.

Is 40 psi too much for tires?

Higher pressure generally is not dangerous, as long as you stay well below the “maximum inflation pressure.” That number is listed on each sidewall, and is much higher than your “recommended tire pressure” of 33 psi, Gary. So, in your case, I’d recommend that you put 35 or 36 psi in the tires and just leave it there.

Is 35 psi too high?

Higher pressure generally is not dangerous, as long as you stay well below the “maximum inflation pressure.” That number is listed on each sidewall, and is much higher than your “recommended tire pressure ” of 33 psi, Gary. So, in your case, I’d recommend that you put 35 or 36 psi in the tires and just leave it there.

How do I know if my tractor tires are filled?

If the tires are loaded, have the valve stem at 6 O’clock position and push in the core like you are going to check pressure. If loaded you will get liquid come out instead of air. Loaded tires are usually filled to the 10 O’clock position or about 75%. This is done so the liquid in the tires is above the wheel.

You might be interested:  FAQ: What Do The Utensils Mean In Michelin Guide?

Can you put air in a loaded tractor tire?

As you know, water is not very compressible, so a tractor tire needs air for the cushion. The air will compress and give a little. therefore soften the ride. When you try to air up the tire, the tire should be fully on the ground.

Will 10 ply tires last longer?

most 10 ply tires have a harder rubber compound and will last longer than a 6 ply tire.

What PSI should I run BFG ko2?

BFGoodrich All-Terrain T/A KO2 Tire Pressure Chart

Tire Size Max Load Capacity (single / dual rear wheels) Max Tire Pressure
LT265/70R16 121S 3197 lbs 80 psi
LT265/70R17 112S 2469 lbs 50 psi
LT265/70R18 124R 3527 lbs 80 psi
LT265/75R16 123R 3417 lbs 80 psi

What is the recommended tire pressure for LT tires?

The lowest PSI that the TRA recommends for LT tires is 35 PSI. That 35 will support a certain load, but even if you don’t need to support that much of a load, it is still recommended to run 35 PSI.

Should all 4 tires be the same PSI?

Often, the vehicle manufacturers specify more air pressure in the back for this very reason. (Sometimes, not often, they specify a couple of pounds lower in the rear, but rarely more than 2 psi.) A good rule of thumb would be to keep the same variance front to rear that the vehicle manufacturer recommends.

Is 50 psi too much for tires?

Every tire has a rated maximum inflation pressure. Often it will be found in small print around the rim edge of the sidewall. This means that the tire will safely carry up to 1477 lbs. and can be safely inflated up to 300 kPa (Kilopascal) or 50 psi (pounds per square inch).

You might be interested:  How Long Do Michelin Ltx Ms2 Tires Last?

Should all 4 tires have the same PSI?

Tire pressure differences between front and rear is acceptable. Car manufacturers don’t usually set them up that way in most cars, some do – it depends on the car. Car manufacturers don’t usually set them up that way in most cars, some do – it depends on the car.

Leave a Reply

Your email address will not be published. Required fields are marked *